Hi,
I am new to the tool but managed to load SRTM tiles into my map surface. Each tiles is a 1° by 1° set of terrain altitudes, raster data. More than one tile is loaded at the time.
If the complete map is shown then everything looks all right.
If one zooms in, then the transition zone from one tile to the other both in latitude and longitude direction is not shown correctly. It seems that after the zoom action two tiles are shown one over the other and not next to each other.
Did somebody see a similar behaviour anc maybe has a solution for that?
Thanks
I am new to the tool but managed to load SRTM tiles into my map surface. Each tiles is a 1° by 1° set of terrain altitudes, raster data. More than one tile is loaded at the time.
If the complete map is shown then everything looks all right.
If one zooms in, then the transition zone from one tile to the other both in latitude and longitude direction is not shown correctly. It seems that after the zoom action two tiles are shown one over the other and not next to each other.
Did somebody see a similar behaviour anc maybe has a solution for that?
Thanks
