Hello.
Notice some strange behaviour when I tried to change default drawing style of multipart polyline shape file.
I created memory maultipart polyline shape file and after I added shapefile to the map everything looked correct.
If I increase line thickness (width > 1) then I see on a map only second part of each line.
Could you advise on this matter?
P.S. I used 62103 version. Also when I created multipart shape I kept in mind that first part of eqach shape is added automatically.
Comments: The issue was fixed as mentioned in comments.
Notice some strange behaviour when I tried to change default drawing style of multipart polyline shape file.
I created memory maultipart polyline shape file and after I added shapefile to the map everything looked correct.
If I increase line thickness (width > 1) then I see on a map only second part of each line.
Could you advise on this matter?
P.S. I used 62103 version. Also when I created multipart shape I kept in mind that first part of eqach shape is added automatically.
Comments: The issue was fixed as mentioned in comments.